Bush Plane
Shockcub.czBushFly.czwww.zlinaero.com
An error occurred while sending an authentication request to the PSC Single Sign-On server
After successful isntallation of vCenter 6.7 I run into this error and could not resolve it much. After reading several threads I did not have much luck resolving this. Will post later once the issue is resolved for good. Sources:…
Rotax 912 popis
Service manual:
vCenter – 503 Service Unavailable – Failed to connect to endpoint
In case you got this message „N7Vmacore4Http20NamedPipeServiceSpecE:0x00005649c2730ad0] _serverNamespace = / action = Allow _pipeName =/var/run/vmware/vpxd-webserver-pipe)“ You’re getting a failure because you are not using a FQDN (hostname plus domain name) which you *must* use. And, yes, you *must* have forward…
Cannot add ESXi 6.7 hosts to cluster: A general system error occurred: Unable to push CA certificates and CRLs to host
Joining new hosts failed with certificate issues – I was getting certificate issues when trying to join NEW hosts to a new host cluster in this datacenter in vSphere. There is a vCenter setting (vCenter -> Configure -> Settings ->…
How to Install/Re-install ESXi 6.7
Thanks to Michael Frauenhoffer for this guide which can be used also during VMware reinstallation. I run into trouble after enabling some pass through functions and ended up with dma_mappon_iommu load successfully but get stuck at that point with no…
Setting dns server CentOs-8
setting This detailed tutorial will help you to set up a local DNS server on your CentOS 7 system. However, the steps are applicable for setting up DNS server on RHEL and Scientific Linux 7 too. DNS Server Installation Scenario…
Zabbix IPMI configuration
4 IPMI checks Overview You can monitor the health and availability of Intelligent Platform Management Interface (IPMI) devices in Zabbix.To perform IPMI checks Zabbix server must be initially configured with IPMI support. IPMI is a standardized interface for remote “lights-out” or “out-of-band”…
How to Configure Boot from iSCSI with VmWare
Issue This guide intends to assist customers on configuring HP ProLiant servers with Broadcom Multifunction NICs in order to boot off an iSCSI target and have MPIO configured (either during OS operation and NIC failover at server boot). The Broadcom…
Zabbix – IPMI configuration in ILO HP
Confiruge ILO IP address Enable IPMI in ILO in ILO create IPMI user Verify that port 623 is up and running [root@vm1zabbix ~]# nmap -sU 192.168.0.196 -p 623Starting Nmap 7.70 ( ) at 2020-04-11 09:28 CESTNmap scan report for…